Why not Do it youself. You can purchase any Stock Rhinestone Design or Custom Rhinestone Design and apply it to your own garment or craft.

To purchase a stock design click on the Do It Yourself: BUY NOW button found on the specific design page. If you would like to purchase a Do It Yourself Custom Design just follow the instructions on the Custom Rhinestone Design page and indicate in your email Do It Yourself.

Application Instructions:

1. Carefully remove the white backing
2. Position and press the design into the fabric. The clear adhesive film will hold the design in place
3. Always iron on a hard flat surface
4. Set iron on medium or wool setting. NO STEAM OR MOISTURE. Approximately 350 degrees is best for this process.
5. Place a piece of lightweight cloth over top of the design.
6. Use medium amount of pressure on the iron. DO NOT MOVE the iron back and forth, keep in on the pressing cloth for 30 seconds. (Heavier fabrics require more time, lighter fabrics require less time.)
7. Allow design to cool for approx. 2 minutes. Using care gently remove the clear plastic film away from garment.
8. Again, place lightweight cloth over top of the design and press of an additional 30 seconds.

Tips:

You may reposition design before ironing. If you move a crystal out of postion, use a tweezer and carefully replace the crystal in it's original position.

ONCE IRONED ON, the design is PERMANENT

Care Instructions:

Turn garment inside out and wash on gentle cycle, air dry or dry clean.